Help with AP350/LEAp/Steelbelt RADIUS/DHCP IP Assignment

[ahazim]

HI,

I am having troubles with RADIUS and CISCO LEAP. I have managed to get the users authenticating to the RADIUS box via LEAP ok.

The problem assises when I try to obtain an IP Address from the RADIUS box itself. Whenever I specify the RADIUS box to assign the IP it never get accepted by the clients (running win98/win2k/win xp/win ce). I can see the IP address being returned by the RADIUS box in its logs but cannot figure out how the client is supposed to accept the address.

I was wondering if anybody out there has accomplished this task and I would greatly like to converse with them about how they did it.

Any help would be greatly appreciated.

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.