How do you enable or start using RTS/CTS. The layout of my network is long hallways with rooms on either side with AP's in hall and Nodes in the rooms off the hallway. I am sure I am running into the Hidden node problem but don't know how to enable my clients and/or AP's to start using RTS/CTS.
The Clients are Dell True Mobile and CB21AG and the AP's are 1200's. For some reason I remember there was a setting in the older cisco cards but don't seem to find it in the latest CB21AG software.
Set the RTS Threshold on the AP.... as per Cisco's documentation
This setting determines the packet size at which the device issues a request to send (RTS) before sending the packet. A low RTS Threshold setting can be useful in areas where many client devices are associating with the access point or in areas where the clients are far apart and can detect only the access point and not each other.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...