Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

High CPU on 2921 with EHWIC card

Hi,

I am getting the following error message on a Cisco 2921 as a result of which has a there is 99 % CPU util. This router has the following cards installed and 4G WWAN EHWIC is running 15.1(4) M3 image.

EHWIC_CELL_MSG-1-EHWIC_ERROR_EVENTS: eHWIC Error Event: TxCLK PLL lost lock, HWIC slot 3

Anybody encountered the same error message ?

Thanks,

Pranay

Everyone's tags (4)
1 REPLY

Re: High CPU on 2921 with EHWIC card

Hi Pranay,

High cpu utilization is usually due high broadcast traffic that hits the device. You can use packet capture to verify.

If it is the case then try to isolate vlans that causes the broadcast to the device.

HTH

Amjad

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
728
Views
0
Helpful
1
Replies
CreatePlease login to create content