A new project require us to set up 2 AP 1200 in a room, and to configure one of the AP in standby mode. I've followed closely to the CCO documents on hot standby setup but couldn't get the standby AP to associate to the Active AP.It always give the status init assoc "Failed".
When the target location is an access point, you can specify the radio interface MAC addresses for the access point that the standby unit monitors. Hot Standby mode designates an access point as a backup for another access point. Typically, the standby access point is placed near the access point it monitors and is configured exactly the same.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...