Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How do you factory default the MSE 3350 Mobility Solution Engine

Hi Guys

I was wondering if anyone knows how to factory default the MSE or know of a way to enable the setup wizard again.

Is there a way to check the status or change the WCS communication password manually.

Thanks in advanced

2 REPLIES
Bronze

Re: How do you factory default the MSE 3350 Mobility Solution En

You can use following steps to restore factory default fo MSE:

Step 1 In Cisco WCS, click Mobility > Mobility Service Engines.

Step 2 Click the name of the mobility services engine you want to configure.

Step 3 Click System (left panel).

Step 4 Click Advanced Parameters.

Step 5 In the Advanced Commands section (right), click Clear Configuration.

Step 6Click OK to clear the mobility services engine configurations.

Hall of Fame Super Silver

Re: How do you factory default the MSE 3350 Mobility Solution En

You can also run this from the cli to get the startup wizard:

/opt/locserver/setup/setup.sh

-Scott
*** Please rate helpful posts ***
2754
Views
0
Helpful
2
Replies
CreatePlease to create content