09-15-2008 09:32 AM - edited 07-03-2021 04:29 PM
Hi Guys
I was wondering if anyone knows how to factory default the MSE or know of a way to enable the setup wizard again.
Is there a way to check the status or change the WCS communication password manually.
Thanks in advanced
09-15-2008 03:13 PM
You can use following steps to restore factory default fo MSE:
Step 1 In Cisco WCS, click Mobility > Mobility Service Engines.
Step 2 Click the name of the mobility services engine you want to configure.
Step 3 Click System (left panel).
Step 4 Click Advanced Parameters.
Step 5 In the Advanced Commands section (right), click Clear Configuration.
Step 6Click OK to clear the mobility services engine configurations.
09-15-2008 05:54 PM
You can also run this from the cli to get the startup wizard:
/opt/locserver/setup/setup.sh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide