I tried it running HREAP (why did Cisco change the name?)....it works great IF and only if the access point was previously associated to the controller and the code version was previously synced. Tried using an AP that needed to sync to an updated image...I gave up after 20 minutes...the connecton is really slow and the latency is horrible compared to DSL, T1 or L2L VPN...
A 1262 running an autonomous image works great, and as I only have 6 sites on satellite connections, I think this is the way to go.
I would agree some things are left to be in autonmous mode. This sounds like one of them times. Although, HREAP would work, but as you seen code pushing and the little extra overhead could use expensive sat bandwidth.
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...