Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How to add an AP to AP Group on redundant controller?

I have AP Groups configured and working fine on my primary WLC. I can find no way to add APs to the AP Groups that I have defined on my redundant WLCs.(short of associating the APs to each of the redundant controllers, adding the APs to the AP groups etc.)

1 X Primary = WLC 4404 v4.0.206

3 X Redundant = WLC 4102 v3.2.193.5

3 REPLIES
Silver

Re: How to add an AP to AP Group on redundant controller?

Before you configure the AP Group VLANs feature, you must configure the WLC for basic operation and register the LAPs to the WLC. Refer URL

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml#c2

Bronze

Re: How to add an AP to AP Group on redundant controller?

The AP Group Name assigned to an AP is one of the config parameters the AP stores locally in NVRAM and carries with it to a new controller. So, as long as the AP Group Name is the same on the redundant WLCs as it is on the primary, you're golden.

New Member

Re: How to add an AP to AP Group on redundant controller?

Thanks, I will test this next maint. period. Another thing to add to the documentation :>)

172
Views
6
Helpful
3
Replies
CreatePlease to create content