My customer has a 1:1 cluster, now I want to change the setup for OEAP600, this means I have to set the NAT Address on the Management Interface.This seems not be possible in a 1:1 Cluster. -> I have to break the cluster, set the NAT Address and make it a cluster again.
Instead of building the cluster again I would like to make it to a N+1 failover. Yes, I loose AP and Client SSO but will have other advantages.
What do I need to do if I want to make a N+1 from a 1:1 Cluster?
What happens with the actuall config on the secondary after disabling SSO?
Easy... Sort of. You need to disable AP SSO and then what I would do is default the redundancy IP on the primary and factory default the on that was the HA pair. Then configure the HA pair as a normal WLC and setup the access points high availability
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...