How to config LAP1142n ap's for vty access via tacacs+?
Can an AIR-LAP1142N be setup for vty access with tacacs+ authentication via command line on the AP? or does this have to be done on the WLC? This would be strictly for network administration of the ap not for granting access to wireless clients.
Also, any links to documentation that show the configuration of tacacs+ on the AP (or if only on the wlc specifically the 5508 with version 6) would be helpful.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...