Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure Catalyst 2960-s switch to allow communication between two Wireless Clients on two different VLANs ?

How to configure Catalyst 2960-s switch to allow communication between two Wireless Clients on two different VLANs. Couldn't able to do data transfer between two wireless clients.

Test setup:

Test setup includes Cisco 1240 AP, Catalyst 2960-s switch and Cisco ACS for EAP-FAST authentication.

Cisco 1240 AP and Cisco ACS Configuration:

1.AP IP Address : 192.168.6.3.
2.Configured two SSIDs with two different VLANs (VLAN 2: TKIP, VLAN3: CCMP) and configured the VLAN1 as native VLAN.
3.Connected the Cisco ACS to the Cisco 1240 AP and configured for EAP-FAST authentication.

Catalyst 2960-s switch Configuration:

Switch#configure terminal 
Switch<config>#interface fastethernet 0/1
Switch<config-if>#switchport mode trunk
Switch<config-if>#switchport trunk native vlan 1
Switch<config-if>#switchport trunk allowed vlan add 1,2,3
Switch<config-if>#switchport nonegotiate

1 ACCEPTED SOLUTION

Accepted Solutions

Layer 3 so the clients are

Layer 3 so the clients are able to route between each other. the 2960 is a layer 2 switch, since you are doing inter-VLAN you need some L3 in there.

 

--

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
3 REPLIES

What are you using for your

What are you using for your L3 gateway? if you are going cross VLAN you have to have a L3 gateway configured 

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Thanks Steve for your reply

Thanks Steve for your reply.

You mean L3 gateway to be configured on switch ?

 

Thanks,

Harsha

Layer 3 so the clients are

Layer 3 so the clients are able to route between each other. the 2960 is a layer 2 switch, since you are doing inter-VLAN you need some L3 in there.

 

--

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
252
Views
0
Helpful
3
Replies
CreatePlease to create content