Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to configure IP Address filter in Controller based Access Points ?

Dear Team,

 

Configuration:

i have 5508 series controller and joined the two Thin APs to the controller. WLAN controller is connected to PC where Multicast receiver is running for two Multicast IP addresses (IP1: 230.1.1.1, IP2: 230.1.1.2). Multicast sender is running for two IP addresses on Station.

Requirement:

When Station is associated to AP1, AP1 should block the multicast packets going to AP2 and vice versa . That is AP1 should be configured to block multicast packets going to 230.1.1.2 and AP2 should be configured to block multicast  packets going to 230.1.1.1.

 

Thanks,

Harsha

 

 

1 REPLY
Bronze

I believe you could apply

I believe you could apply ACLs and check if that helps.

For more details about configuring ACLs, please refer to the following link:

http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_0110101.html#task_AA3AFA57D51647478E0C3511137C165E

 

Hope that helps.

33
Views
0
Helpful
1
Replies