Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure session time-out on Cisco autonomous AP?

Dear Team,

Can you provide command for configuring session timeout on Cisco autonomous AP (1242 AP).

Thanks,

Harsha

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi Harsha,If it is 802.1X

Hi Harsha,

If it is 802.1X enable WLAN, you can try below command under radio interfaces (ie int d0 & int d1).

dot1x client-timeout x

If you want to set re-auth time, then you can use below. If you use "server" keyword then it will use the value send by your RADIUS server.

dot1x reauth-period { seconds | server }

Here is the command reference guide.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-2_8_JA/command/reference/b1228cr/bcrmain.html#wp2454010

HTH

Rasika

**** Pls rate all useful responses ****

2 REPLIES
VIP Purple

Hi Harsha,If it is 802.1X

Hi Harsha,

If it is 802.1X enable WLAN, you can try below command under radio interfaces (ie int d0 & int d1).

dot1x client-timeout x

If you want to set re-auth time, then you can use below. If you use "server" keyword then it will use the value send by your RADIUS server.

dot1x reauth-period { seconds | server }

Here is the command reference guide.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-2_8_JA/command/reference/b1228cr/bcrmain.html#wp2454010

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Thanks Rasika

Thanks Rasika

649
Views
0
Helpful
2
Replies
CreatePlease login to create content