Re: How to include Aironet 340 Dos Driver on a Dos bootdisc
These drivers are left over from Aironet pre-Cisco acquisition so theres not much documentation. I dont see DOS support for the 350s but the 340s are still out there. In any case, edit the .ini or .ahc (ad hoc file is only used if no access point is being used, just peer-to-peer) files with your text editor to set the options you desire. Then put those and the .com packet driver on your boot disk, load the .com with a device statement in the cofig.sys and it should initialize the card. If you are using a PCMCIA card, make sure you load a DOS compatible card services BUS driver first.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...