How to increase the time for detect a device down on Prime 2.0
I would like to know how to increase the time for detect when a device has lost connection, currently I monitor several stand alone Access Points that are paleced on differents locations connected to prime through 256 Mbps Links, so when the location has very high bandwith utilization, an e-mail notification about the unreachable Access Point is sent, but if we check te reachability, the Access Point is reachable, and we don´t want to receive to many of this notificatios,
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...