Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to load a boot image to cisco aironet 1140 series after missing boot image

Hi all,

I need a solution for this. When i switch my cisco aironet 1140 , it s blinking with red light .and gives a message "no boot image to load".

When i tried next time, by pressing escape it shows this message that i have mentioned below.

ap:

ap:

using  eeprom values

WRDTR,CLKTR: 0x83000800 0x40000000

RQDC ,RFDC : 0x80000035 0x00000208

using ÿÿÿÿ ddr static values from serial eeprom

ddr init done

Running Normal Memtest...

Passed.

IOS Bootloader - Starting system.

FLASH CHIP:  Numonyx P33

Checking for Over Erased blocks

................................................................................                                                                             ................................................................................                                                                             ................................................................................                                                                             ......

Xmodem file system is available.

DDR values used from system serial eeprom.

WRDTR,CLKTR: 0x83000800, 0x40000000

RQDC, RFDC : 0x80000035, 0x00000208

PCIE0: link is up.

PCIE0: VC0 is active

PCIE1: link is NOT up.

PCIE1 port 1 not initialized

PCIEx: initialization done

flashfs[0]: 1 files, 1 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 32385024

flashfs[0]: Bytes used: 1536

flashfs[0]: Bytes available: 32383488

flashfs[0]: flashfs fsck took 16 seconds.

Reading cookie from system serial eeprom...Done

Base Ethernet MAC address: 28:94:0f:d6:c8:62

Ethernet speed is 100 Mb - FULL duplex

The system is unable to boot automatically because there

are no bootable files.

C1140 Boot Loader (C1140-BOOT-M) Version 12.4(23c)JA3, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Tue 18-Oct-11 14:51 by prod_rel_team

ap:

So , now my question is how to load the boot image ? From where will we get this ? OR

I m also having another Cisco aironet 1140 , Can i get bootimage from that . Kindly let me know the solution from genius ?

Everyone's tags (4)
1 REPLY
Hall of Fame Super Silver

Re: How to load a boot image to cisco aironet 1140 series after

Take a look at this link as it should have the info you need

https://supportforums.cisco.com/docs/DOC-14636

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
1711
Views
0
Helpful
1
Replies