Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to replace an AP on the WCS map

I have an out of service AP 1131. I have a replacement ready to install but I'm concerned w/ the map on the WCS. How can I go about replacing the existing AP w/ the new AP while using the existing name?

Robert Maldonado

Sr. Systems Administrator

2 REPLIES
New Member

Re: How to replace an AP on the WCS map

Robert,

After installing the new AP and get it sync'd up with the controller.Rename the new AP. Then simply delete the first one from the map and add the newly installed AP to the map.

Shouldn't be to bad at all.

New Member

Re: How to replace an AP on the WCS map

Erik,

While it wasn't as easy as I would have hoped deleting the existing one prior to adding the one one worked out fine.

Thanks for your suggestion.

134
Views
0
Helpful
2
Replies
CreatePlease login to create content