Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to see in command line if the SSID is set to broadcast

Can someone tell me the command to see from the command line if i have broadcast set up for the SSID

EDIT

I resolved this, I overlooked the guest-mode

1 REPLY
Silver

Re: How to see in command line if the SSID is set to broadcast

You can see in the command sh running-config command

show running-config : Displays the current access point operating configuration

Use the guest-mode SSID configuration mode command to configure the radio interface (for the specified SSID) to support guest mode. Use the no form of the command to disable the guest mode.

[no] guest-mode .

Here is the guideline for usage

The access point can have one guest-mode SSID or none at all. The guest-mode SSID is used in beacon frames and response frames to probe requests that specify the empty or wildcard SSID. If no guest-mode SSID exists, the beacon contains no SSID and probe requests with the wildcard SSID are ignored. Disabling the guest mode makes the networks slightly more secure. Enabling the guest mode helps clients that passively scan (do not transmit) associate with the access point. It also allows clients configured without a SSID to associate.

Examples

This example shows how to set the wireless LAN for the specified SSID into guest mode:

AP(config-if-ssid)# guest-mode

This example shows how to reset the guest-mode parameter to default values:

AP(config-if-ssid)# no guest-mode

524
Views
0
Helpful
1
Replies