06-08-2009 06:40 AM - edited 07-03-2021 05:41 PM
Hi,
I'm using two 4402 running the following versions:
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 5.2.157.0
RTOS Version..................................... 5.2.157.0
Bootloader Version............................... 4.2.112.0
Emergency Image Version.......................... 5.2.157.0
Build Type....................................... DATA + WPS
Where can I set the speed/duplex mode for the APs?
In earlier versiones there was a "config ap ethernet"-command.
Any ideas?
Regards Dirk
06-08-2009 12:03 PM
This works in 5.0.148.2
config AP ethernet duplex (x) speed (x) (AP NAME)
06-08-2009 11:58 PM
Thanks for the reply,
but I don't want to downgrade.
Does anyone know if thess commands are back in the upcoming versions?
regards
06-09-2009 03:10 AM
Yes ,
These commands are there new versions.
Haven't checked in the version you mentioned,But should not have got removed.
Thanks
Vinay
06-09-2009 03:30 AM
Good to know.
Any suggestion when Version 6.x will be available for 440x series?
Regards Dirk
07-01-2009 12:48 PM
Just to let you all know,
Issue is fixed in version 6.0
regards
07-01-2009 12:48 PM
Just to let you all know,
Issue is fixed in version 6.0
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide