Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to set speed and duplex for APs

Hi,

I'm using two 4402 running the following versions:

(Cisco Controller) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 5.2.157.0

RTOS Version..................................... 5.2.157.0

Bootloader Version............................... 4.2.112.0

Emergency Image Version.......................... 5.2.157.0

Build Type....................................... DATA + WPS

Where can I set the speed/duplex mode for the APs?

In earlier versiones there was a "config ap ethernet"-command.

Any ideas?

Regards Dirk

regards, Dirk (Please rate if helpful)
6 REPLIES
New Member

Re: How to set speed and duplex for APs

This works in 5.0.148.2

config AP ethernet duplex (x) speed (x) (AP NAME)

New Member

Re: How to set speed and duplex for APs

Thanks for the reply,

but I don't want to downgrade.

Does anyone know if thess commands are back in the upcoming versions?

regards

regards, Dirk (Please rate if helpful)
Cisco Employee

Re: How to set speed and duplex for APs

Yes ,

These commands are there new versions.

Haven't checked in the version you mentioned,But should not have got removed.

Thanks

Vinay

New Member

Re: How to set speed and duplex for APs

Good to know.

Any suggestion when Version 6.x will be available for 440x series?

Regards Dirk

regards, Dirk (Please rate if helpful)
New Member

Re: How to set speed and duplex for APs

Just to let you all know,

Issue is fixed in version 6.0

regards

regards, Dirk (Please rate if helpful)
New Member

Re: How to set speed and duplex for APs

Just to let you all know,

Issue is fixed in version 6.0

regards

regards, Dirk (Please rate if helpful)
192
Views
0
Helpful
6
Replies