Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to tell where AP is getting its power?

Is there a statement or debug command to tell how an AP is being powered? Via Power Injector or Inline power? We have Aironet 1230's deployed at some remote sites and want to determine how they are being powered.

1 REPLY
New Member

Re: How to tell where AP is getting its power?

Well im unaware of a command or debug... however you could do a show cdp neighbor to aquire the switch port, then cycle the port.. Based on the lenght of time it takes for the AP to become accessable you could determine if it was an injector or not.

143
Views
0
Helpful
1
Replies