cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
284
Views
0
Helpful
1
Replies

How to tell where AP is getting its power?

mlitka
Level 2
Level 2

Is there a statement or debug command to tell how an AP is being powered? Via Power Injector or Inline power? We have Aironet 1230's deployed at some remote sites and want to determine how they are being powered.

1 Reply 1

robertham
Level 1
Level 1

Well im unaware of a command or debug... however you could do a show cdp neighbor to aquire the switch port, then cycle the port.. Based on the lenght of time it takes for the AP to become accessable you could determine if it was an injector or not.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: