Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HREAP Problem

I have to configure an Access Point 1311 in remote site to be asociated with WLC in Central site. I have followed the following prcedure to do the same.

1.Configuring an AP in H-REAP Mode.

a.Connect AP in the switched network; configure the port under default VLAN inorder to acquire an IP address.

b.Once the AP got registered with WLC. Click “All APs” and click on the details button of the specific AP to configure an IP address & Hreap.

c.Configure an IP address, SNM & Default Gateway of the remote office subnet and

select HREAP from the AP Mode drop down menu,

d.Enable the HREAP Local switching check box, if you an AP to do local switching.

2.Configuring WLC in H-REAP.

1. Click WLANs in order to create a new WLAN, and then click Apply.

2. Choose 802.1 x authentications in the Layer 2 Security field.

3.Under the Radius Servers section, choose the appropriate server configured for authentication

4.Check the H-REAP Local Switching check box in order to switch client traffic that belongs to this WLAN locally at the H-REAP

WLC Ap manager IP and Management IPs are in default subnet.

But Access Point is not getting associated with the controller when testing the same from remote site.

  • Other Wireless - Mobility Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: HREAP Problem

May I request if you can tick the "Resolved" option?

4 REPLIES
Hall of Fame Super Gold

Re: HREAP Problem

What happen to your VLAN Assignments?

Go to the AP, click on the H-REAP tab, click Enable VLAN Support, enter the Native VLAN ID, click on VLAN Mappings.

Hall of Fame Super Gold

Re: HREAP Problem

Thanks for the rating.

New Member

Re: HREAP Problem

thanks for your help...we have successfully implemented HREAP...

Hall of Fame Super Gold

Re: HREAP Problem

May I request if you can tick the "Resolved" option?

182
Views
4
Helpful
4
Replies