Will a 50 ohm load on the antenna port sufficiently drop the received signal level?
For a test, I have an HWIC-3G-CDMA card and an HWIC-4B-S/T card. The BRI card is connected to a satellite data terminal for an ISDN connection. The 2811 router is connected to the cellular network and I want to check the fail-over capability to the ISDN connection. I have been able to disconnect the cellular antenna and the received signal drops to sufficiently fail over to the ISDN connection. However, lately my received signal is great enough that even removing the antenna doesn't lower the received signal enough. Will a 50 ohm load/termination work on the antenna port? Or would an RF antenuator be better?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...