08-07-2007 05:41 PM - last edited on 07-03-2021 02:27 PM by cc_security_label
Can anyone remeber what the command is to make the LED flash on the 1130AG Access Point?
08-08-2007 04:40 AM
Hi Alan,
Here you go;
This example shows how to blink the access point LEDs for 30 seconds:
AP# led flash 30
This example shows how to stop the blinking of the access point LEDs:
AP# led flash disable
This example shows how to display the LED flashing status:
AP# show led flash
From this good doc;
http://www.cisco.com/en/US/docs/wireless/access_point/12.2_8_JA/command/reference/i8crios.html#wpmkr2425497
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: