I work in an office where the wireless routers are so close together that now, while I am trying to document each router and their MAC addresses I cannot differentiate which is which. I was wondering if there is a way to hardwire into each router and determine it that way. Please note, reading the MAC off of the router itself is not possible as they are installed in a way that I cannot see.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...