I would like to use mDNS AP to send mDNS packet to the WLC (source vlan are not visible to the WLC).
I saw in the documentation that APs can either be in access or trunk mode to learn the mDNS packets from wired side and forward it to the controller.
According to the documentation
The trunk mode allows the user to specify the VLANs from which the AP should snoop the mDNS advertisements from wired side. The maximum number of VLANs that AP can snoop is 10.
If the AP is in access mode, AP will send untagged packets when a query is to be sent. When an mDNS advertisement is received by mDNS AP, VLAN information is not passed to the controller. Hence the service provider’s VLAN, learnt via mDNS AP’s access VLAN will be maintained as 0 in the controller.
In my understanding, AP in access mode logically transfert mDNS packets receive from his access vlan to the WLC. So,if I want to snoop and transfert mDNS packets receive from several vlan I need to configure APs in trunk mode and snoop up to 10 vlan.
According to the documentation below, APs in access mode can transfer mDNS packets from all the vlan to the WLC.
So, I don't understand how mDNS works with APs in access mode (and it's my case). Unfortunaly I can't try it to my lab.
Please could you help me to understand this fonctionnality ?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...