Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Indoor mesh with 2106 and 1131 AG

Hello all,

   I am trying to create a 1 root 2 map indoor mesh using the 2106 controller and 1131 AG AP's.  Code train is 7.0.98.  I convert the first AP to bridge mode prior to assigning it as the root and the AP reboots and never rejoins the controller.  I wind up having to delete the private config before it will rejoin.  So I have 2 questions: 1. will this hardware/software combination work and 2. if it will work where am I going wrong?

Thanks in advance!

Bill

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Indoor mesh with 2106 and 1131 AG

You are fine with that hw/sw combo.  Did you add the AP's mac address to the mac filter list on the controller?  When an AP is in bridge mode it has to be added to the mac filter list to be able to join.

2 REPLIES
Gold

Re: Indoor mesh with 2106 and 1131 AG

You are fine with that hw/sw combo.  Did you add the AP's mac address to the mac filter list on the controller?  When an AP is in bridge mode it has to be added to the mac filter list to be able to join.

New Member

Re: Indoor mesh with 2106 and 1131 AG

_

348
Views
9
Helpful
2
Replies