While auditing a client (using Kismet) I found that some of their Cisco APs have a <info> field in beacon packets. I'm trying to figure out where the data for this field is entered in the configuration. I do not have access to the configurations. The data is not the SSID but in some cases is similar.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...