Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Infocus LiteShow II wireless projector adapter

Hi Everyone,

I just wanted to know if anyone has worked with the LiteShow II adapter and LWAPP ap's. I have a problem where I set up a WPA-PSK network and the device fails to connect. The client status said that it failed the authentication policy on the WLC. From a laptop everything works fine. I just can't get the device to connect to my LWAPP 1242's. I contacted Infocus about this and they are very slow to respond. I even tried the connection to the wlan with everything set to "open" mode. That didn't work either. Is there some kind of policy that I need to change to allow 3rd party AP's to connect to the wlan as a client? It's almost like a WGB, where the client connects to the Infocus, gets a 10.0.0.x address, and then the infocus bridges the 10.0.0.x network with the wlan's network. Is that not supported with LWAPP ap's? Any insight would be helpful.

2 REPLIES

Re: Infocus LiteShow II wireless projector adapter

We had a similar issue with projectors from a different manufacturer. Try setting the IP addy of the projector manually and if there is a gateway setting on the projector point that to the IP addy of the AP. Also make sure that you have layer 3 for LWAPP transport. Layer 2 will not work.

New Member

Re: Infocus LiteShow II wireless projector adapter

Dennis, what a fantastic concept! I should have thought about that. I will try your suggestions and let you know the results.

1175
Views
0
Helpful
2
Replies