Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inital setup of 1200

Hi all,

I posted another question about not being able to get my 1200 working with clients but I think I need to take a step back and take a closer look at my initial setup. I have this AP on a switchport but after thinking about this, I have vlans I wish to also have on the AP. Can this AP be put on a trunked port just like a switch? If so, how does this work? I have done the setup of the trunked port and the associated sub interfaces on the AP but cannot get a successful link. Can someone shed some light on this config?

2 REPLIES
New Member

Re: Inital setup of 1200

Thanks for your reply. I have followed these guides and believe I have a working initial setup. The radio interface is up up and I have configured it to work with my windows IAS but I am still unable to connect from my clients. does my config look like it would be a working config?

105
Views
0
Helpful
2
Replies