Inital setup of 1200

[rhltechie]

Hi all,

I posted another question about not being able to get my 1200 working with clients but I think I need to take a step back and take a closer look at my initial setup. I have this AP on a switchport but after thinking about this, I have vlans I wish to also have on the AP. Can this AP be put on a trunked port just like a switch? If so, how does this work? I have done the setup of the trunked port and the associated sub interfaces on the AP but cannot get a successful link. Can someone shed some light on this config?

[Sushil Kumar Katre]

Hi,

Is this what you are talking about -

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080665ceb.shtml

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml

-> Sushil

[rhltechie]

Thanks for your reply. I have followed these guides and believe I have a working initial setup. The radio interface is up up and I have configured it to work with my windows IAS but I am still unable to connect from my clients. does my config look like it would be a working config?