I have tried to configure an ip address ina A WGB-350, but the IPSU returns this message (THE DEVICE DOES NOT ANSWER). I try with a cross cable in a non-network computer and with a direct cable in a network computer, but the device doesn´t answered.
I had the same problem. The best solution is to reset to default your workgroup bridge pressing the "configuration reset button" (see the figure on the "configuration hardware guide" at page 1-2). Thus, you could connect to WGB with a cross cable and web browser (using the default IP address of this device: 192.168.200.1).
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...