Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

INTEGRATING MULTIPLE WLCs 2100

intend to add a second controller and I was wondering how I could handle for instance,the MAC address filtering database. Will I have to add every MAC address to both WLCs or is there an alternative way
Note: I will be configuring mobility group so as to allow roaming

Sent from Cisco Technical Support iPad App

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: INTEGRATING MULTIPLE WLCs 2100

You could always backup the config of the one WLC and then restore it in the other, but don't have it connected to the network. Then you can go change the IP address and hostnames and setup the mobility between the two. Then connect it to the network after you made the changes. This way you can actually mover everything over and not just the MAC address.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Re: INTEGRATING MULTIPLE WLCs 2100

Yes, you need to set up a mobility between the two WLC's and then the changes made in one WLC can be reflected to another. Which will help you to add the MAC address dynamically.

3 REPLIES
Hall of Fame Super Silver

Re: INTEGRATING MULTIPLE WLCs 2100

You could always backup the config of the one WLC and then restore it in the other, but don't have it connected to the network. Then you can go change the IP address and hostnames and setup the mobility between the two. Then connect it to the network after you made the changes. This way you can actually mover everything over and not just the MAC address.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Re: INTEGRATING MULTIPLE WLCs 2100

Thanks a lot for the insight,but I have another question.
Will subsequent change on one WLC replicate to the other ?

Sent from Cisco Technical Support iPad App

Re: INTEGRATING MULTIPLE WLCs 2100

Yes, you need to set up a mobility between the two WLC's and then the changes made in one WLC can be reflected to another. Which will help you to add the MAC address dynamically.

182
Views
0
Helpful
3
Replies
CreatePlease to create content