Could anyone suggest the best way to avoid the interference to the wireless network from an outside wireless network. When a sniffer was connected these networks were found to be operating under different channels but we could see interference from these networks.
The only way that you could avoid the interference is to either move your wireless APs a little bit further out of the way of the outside network if possible or see if the administrator of the other networks will change the transmit power settings on their divices to a lower setting. Unfortunately any device running in the 2.4 Ghz range will cause some interference.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...