cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
292
Views
0
Helpful
3
Replies

Intermittent Connectivity after Implementing WEP

daiku
Level 1
Level 1

I am using an AIR-PCM352 to connect to a 350 series AP that is running 12.03T

Everything appears to operate normally until I implement 128bit WEP on the AP, with open authentication and no broadcast SSID. AT that point, my card loses association with the AP approximately every 3 to 5 minutes. It doesn't matter what signal strength, location, direction, or any other physical factors are involved, the problem is the same.

my NIC has firmware 5.20.17 and I am running ACU 6.1.002

Engineers in the same room do not have any problems with using integrated NICs from their Toshiba laptops.

3 Replies 3

derwin
Level 5
Level 5

What NDIS driver version for the client card ??

NDIS is V8.3.10

NDIS is V8.3.10 - I am still looking for resolution on this problem. I am updating it, hoping that someone might notice it.

Thanks!

Review Cisco Networking products for a $25 gift card