Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
dan
Community Member

Internal DHCP Server on 4402 controller

Hi,

I am trying to setup a guest vlan. I set up an interface for the guest vlan on my 4402 controller. I assigned the guest vlan interface an IP of 192.168.2.10 with a 24 bit subnet mask.

This vlan will go to my DMZ where there is no DHCP server so I need to setup the internal DHCP server. I created a new scope but I'm having trouble with what to put in the Network field for the DHCP scope. The pool addresses are 192.168.2.100-200. with a 24 bit subnet mask.

Every time I try to apply the configuration I get an "error in setting DHCP scope network and netmask".

I've tried using:

192.168.2.10

192.168.2.255

192.168.2.254

as entries for the Network setting but no go. The docs say to enter the IP address used by the management interface with subnet mask applied.

I was assuming they meant the interface for the guest vlan.

What am I doing wrong here?

Thanks.

3 REPLIES
dan
Community Member

Re: Internal DHCP Server on 4402 controller

Never mind. Once I wrote it out I saw my error.

Community Member

Internal DHCP Server on 4402 controller

I know this is an old post but could you please tell me what your solution was

Internal DHCP Server on 4402 controller

Jason:
This is an old post with probably very old code version on the controller.

If you want help please feel free to open a new thread and explain your issue so we better help you.

Rating useful replies is more useful than saying "Thank you"
989
Views
0
Helpful
3
Replies
CreatePlease to create content