Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Internet access for wireless DMZ

I have a wireless router designed to provide visitors just internet access. The wireless router is hanging of the firewall. Here is the configuration I have on the firewall:

ip address inside 10.150.179.2 255.255.255.0

global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
route outside 0.0.0.0 0.0.0.0 64.163.67.201 1

dhcpd address 10.150.179.101-10.149.178.130 inside

dhcpd lease 3600

Now I have the following probem. When a visitor connects to the wireless router, the get an IP fine, but they can't to the internet.

What do I have to do?

Thanks.

2 REPLIES
New Member

Re: Internet access for wireless DMZ

Assuming that NAT is working correctly and the firewall is doing it's job with NAT, have you looked at DNS?  I would verify that you have the correct DNS addresses and that they too are allowed through your FW. 

You problem may be deeper than simple DNS issues, but I would start there.  No DNS = no Internet access.

New Member

Re: Internet access for wireless DMZ

I agree that this might be a DNS issue. Routing and NAT can be checked by i.e. ping 64.163.67.201.

/André

223
Views
0
Helpful
2
Replies