Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Intra controller roaming between 4.0 and 4.1 WLC code

I am testing 4.1 on one contoller but I am having issues roaming from a 4.1 controlled AP to a 4.0 controlled AP.

Should I be able to do this?

If I cant how can I test new code ?

2 REPLIES
Cisco Employee

Re: Intra controller roaming between 4.0 and 4.1 WLC code

Hi Friend,

I believe mobility group domain name is same and you might have configured both the controllers with mobility group config.

Can you check with "sh mobility sum" and confirm the status of your mobility group.

Actually it is good to have same image train on all the controllers in same mobility group.

HTH

Ankur

*Pls rate all helpfull post

New Member

Re: Intra controller roaming between 4.0 and 4.1 WLC code

I did the sh mobility summ command and I see all of my controllers in mobility group.

I know it a good idea ro have all contollers on the same version. I usually change the AP/controller code un my admin building first for a few weeks to test before I deploy to the hospital to make sure I am not deploying a code that could effect patient care.

any other ideas ?

130
Views
4
Helpful
2
Replies
CreatePlease to create content