Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I have a question about downloading a new IOS to all my AP1142N who are connected to WISM2.
I am running version 184.108.40.206 on my WISM2, and the standard AP IOS is 15.2(4)JA1$ . Know a want to upgrade to c1140-k9w7-tar.152-4.JB3a.tar on all my AP1142N.
Is it possible just to upload c1140-k9w7-tar.152-4.JB3a.tar to WISM2 and then reload every AP ?
Johan Lind strand
Go to Solution.
You can't upload images to the WiSM. If you want to change an image on the AP, you need to manually upload it to each AP.Sent from Cisco Technical Support iPhone App
The code the access point will use is from the WiSM. You don't have to upload any image to the AP's at all especially if they are already joined to the WiSM.Sent from Cisco Technical Support iPhone App
Yes i know that.
But the IOS on WISM is 15.2(4)JA1$ . And i want to upgrade my AP to the new IOS version of c1140-k9w7-tar.152-4.JB3a.tar. And that version is not installed on WISM.
Who can i uplaod c1140-k9w7-tar.152-4.JB3a.tar to the WISM ?
Then a got some work to do.
Thanks fore the quick respond
This is the software you need to look at... the lightweight
Thanks, Scott Help out other by using the rating system and marking answered questions as "Answered"
That image you posted is an autonomous image. Once you upload this, your ap's will not joint the WiSM and you aill have to configure these AP's seperate.
Scott Help out other by using the rating system and marking answered questions as "Answered"