Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS upgrade from VxWorks error message?

Here is the error message that I received during the upgrade. The previous upgrade went fine. I was upgrade from VxWorks 12.02.

Memory Bank:File address size encoding type flags

a) Config:AWC_ConfigDB FE020000 156 AiroDB1 Data 0000

b) FLASH :IOS_Upgrade 1.0 FE0A0000 393268 none Exec 0801

c) FLASH :IOS_C350_BOOT 1 FE100034 393256 none 0x09 0800

d) FLASH :IOS_C350_TAR 1 FE16005C 3467304 none 0x0A 0800

e) FLASH :IOS_Upgrade_Envs 1.0 FE4AE884 136 none 0x0C 0800

f) FLASH :AWC PCMCIA FPGA 0.14 FE4AE90C 37380 none FPGA 0000

Cisco IOS automatic field upgrade image, ESC to terminate

..10....9....8....7....6....5....4....3....2....1..

upgrade: Compare ok first load file 0

upgrade: Compare ok first load file 1

upgrade: Compare ok first load file 3

upgrade: IOS Configuration component not available

upgrade: Invalid or missing installation key (BR350 not supported)!

Depress ESC key to reboot

What does BR350 not supported mean. This is not a 350 Bridge. It is a AIR-LMC 350.

Any here would be good. I this a paper weight or can it be saved.

2 REPLIES
Bronze

Re: IOS upgrade from VxWorks error message?

It looks like the installation key is gone. This will result in you having to replace the access point.

Re: IOS upgrade from VxWorks error message?

I had this same error message using a 350 Bridge, and wondered the same thing....

FYI:

I backed out of the install by copying 12.03T Firmware back into the units RAM and then copying it over to flash. It seemed to boot ok (using VxWorks) but came up with an old Aironet (pre Cisco) screen and would only give me one "Role" option which was Site Survey Mode Only (Express Setup page)

219
Views
0
Helpful
2
Replies
CreatePlease login to create content