Is it necessary to config 4400 in Layer 3 Mode to set up AP 1000 series?
Is it necessary to config the Cisco Wireless LAN Controller 4400 in LWAPP Layer 3 Mode to set up AP 1000 series? According to the documentation, the APs should be connected to the controller in LAN and the controller should be in layer 3 to download the OS to APs. After that, disconnect the access point and take
it to its final destination and install it. But when I missed this step, I configured the controller directly in layer2 mode and brought the APs up. Everything works fine. Is it necessary? Is it necessary just for different version of OS?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...