Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
388
Views
0
Helpful
1
Replies

Is it possible to do an automatic "config save to flash" on WCS?

heinz.kern
Level 1
Level 1

‎07-26-2010 05:30 AM - edited ‎07-03-2021 07:00 PM

we want to configure our WLC´s only through WCS. as i saw in the configuration it is only possible to do a manual "save config to flash". this means that we loose the configuration on our controllers when a controller is rebooted in an uncontrolled way (e.g. power loss). is it possible to do an automatic "save config to flash" on every download?

br

heinz

Labels:
0 Helpful
1 Reply 1

Rollin Kibbe
Cisco Employee
Cisco Employee

‎08-18-2010 11:43 AM

Hi Heinz:

Very good choice to only use WCS to make config changes!

I'm not sure I follow what "download" you're referring to.

About the only auto-save is "Save before Backup" on Configure > Controllers > choose a controller by its hotlink > Properties > Settings.  This will cover both scheduled controller config backups and those executed via "Run Now".

Sincerely,

Rollin Kibbe

Network Management Systems Team

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card