02-06-2014 07:04 AM - edited 07-05-2021 12:06 AM
Any advice or link a support matrix for this would be amazing - thanks.
02-06-2014 07:17 AM
HI;
I dont know, if thsi is the answer of your question or not
You can directly upgrade to 7.0.220.0
Upgrade path:
http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_0_220_0.html
Here is the comaptibility matrix :
Reagrds
Dont forget to rate helpful posts
02-06-2014 08:01 AM
Hi,
Thanks for the reply.
I think Ive phrased my question wrong - what i meant to say was is there a minimum sup level required in order to run 7.0.220 on the WiSM?
02-06-2014 09:09 AM
Hi,
Ok now i got your point.
As per my knowledge , you can directly upgarde the WISM software to 7.0.220.0.
You dont need to worry about sup720, there is no need for specific version on this.
Regards
Dont forget to rate helpful posts
02-07-2014 05:41 PM
I think Ive phrased my question wrong - what i meant to say was is there a minimum sup level required in order to run 7.0.220 on the WiSM?
The firmware of the IOS does not decide your 6500 Supervisor.
IF you want to use WiSM-1, regardless of the firmware you have inside, then your supervisor card should be a Sup720 running IOS version SXF2.
This is all you need.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: