Issue getting Motorola 9060G scanner to work with 2602e WPA-TKIP

[Ron Michaels]

I am trying to get a Symbol MC9060G with a new 2602e AP that is a stand-alone.  I have configured the AP for WPA-TKIP with a PSK and it works fine on a laptop. The laptop can use this same profile on the old AP as well as this Cisco 2602e.  The scanner sees the AP but is will not connect to it.

[Rasika Nayanajith]

May be MC9060G does not support TKIP ? Did that work with your old AP using the same security ?

Try first without security & see it associate  & then try to configure security. 

HTH

Rasika

**** Pls rate all useful responses ****

[Ron Michaels]

I set the AP back to factory defaults and the scanner connected just fine. So I added just the configuration lines in the CLI to add WPA to that SSID and that worked also. I will have to be careful in the GUI because the data rate are what I think caused the problem. For the b/g scanners the default is only requiring the 1,2,5.5 and 11 and enabled the rest. I am sure when I was looking around the GUI I changed that setting to best Throughput. All of the other best practiced did not seem to be needed out of the box.