I have two controllers. I am trying to force via the AP configuration (primary, secondary, tertiary) an AP to go to a specific controller. All AP's are static. Good code rev on controllers (184.108.40.206) and I have done this many times. The AP just goes into a constant rebooting mode and attaches only to the primary controller. The only way I can reset it, is by getting to it quickly and resetting the AP to the primary controller. The event log never shows it attempting to contact controller 2 at all? Anyone seen this?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...