Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Issue with mtp2 encapsulation

Hello

I'm trying to setup channel group containing multiply timeslots on 2651XM using ITP IOS.

All is well till trying to setup the encapsulation with the following errors shown :

 

ITP2(config)#int se0/0:0
ITP2(config-if)#enc mtp2
Error in encaps setup.  Encapsulation not changed.
ITP2(config-if)#

 

the 'sh run' for controller E1 shows the following :

controller E1 0/0
 framing NO-CRC4 
 channel-group 0 timeslots 1-31
 g732 ber

 

If I configure channel group containing only one timeslots,everything is fine,but as soon as I tried a channel group containing multiply timeslots I got this error regarding the encapsulation.

 

Any clue perhaps ?

Sincerely

 

99
Views
0
Helpful
0
Replies
CreatePlease to create content