I noticed the other day that there are jumpers inside the 1010 APs and I was just curious on if anyone knows what they are for. I've searched the net with little luck on finding a document that explains this.
It's all just morbid curiosity, but who knows- could be handy information to know.
Excellent question! My understanding of these jumpers (and probably why you can't much info on them) is that they are a left-over from when the AP's were part of the Airespace product line. Before Cisco purchased Airespace. The jumpers could be used to set the AP in a type of Autonomous configuration for doing Site Surveys.
If you google Airespace you may find exactly what jumper went where if you are curious.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...