Are you sure about your AP model? I was not aware that the 1231 shipped in LAP mode? Or did you convert it to LWAPP and now you want to go back to autonomous? Also, I have found that if you rename the default tar file at all, it won't work. Is the word 'default' supposed to be appended to the end of the tar file?
I have figured out the error and have resolved it. The issue was with renaming the file. I renamed using windows rename (F2) that appended .tar extension after default (c1200-k9m7-tar.default.tar) later I renamed using CLI then it worked fine.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...