Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lightening arrestor Won't Fit

Anyone from the Wireless BU out there????

The lightening arrestor with grounding ring will not fit when the bridge is mounted against the wall.

Makes for a sloppy install. This has proved to be a real problem.

Is this going to be changed anytime soon ????

-pat

4 REPLIES
New Member

Re: Lightening arrestor Won't Fit

We have Bridges all ove the campus mounter right againts the wall( no spacers in between) and the Lightning arrestors were placed with out any trouble..

What make are you using ?

Would you like to know the brand we are using ?

New Member

Re: Lightening arrestor Won't Fit

Thanks for the response. We are using the arrestor part # AIR-ACC3354

I don't have the make in front of me. Not sure if these are any different from the ones a few Months ago or not.

But there is no way that these will fit with the ground lug attached with the bridge (350 metal case) flat against the wall.

I will up date this post tomorrow with the specific brand and we can compare.

thanks again

-pat

New Member

Re: Lightening arrestor Won't Fit

Update on brand of Lightening arrestor. The brand is Huber+Suhner

#3406.99.0001

Are there more than One? We simply use the Cisco part number

AIR420-003354

-pat

New Member

Re: Lightening arrestor Won't Fit

Its Huber+Suhner.

I got a chance to see my crew install it, they are suing the 8 gauge copper wire with the lug on it.

After you mentioned it I did aks them if it was tough. I will try and get a picture of it. I am curious since we have few more installs.

After that we would not have any problems since the AP1200 models have a mounting plate supplied.

286
Views
0
Helpful
4
Replies
CreatePlease login to create content